Table of Contents
Advertisement
•
Initiate the FPP feature, and then select the zone and channel.
NOTE: When any of the Rx parameters such as Rx frequency, Rx PL, Rx DPL, and Rx NAC
is changed, FPP automatically copies these Rx parameter values to the equivalent Direct
operation (also known as Talkaround operation) parameters. If you use FPP to change the Rx
frequency to be the same as the Tx frequency and subsequently use the CPS to read then
write to the radio, Direct/Talkaround mode will operate differently from when a receive channel
parameter value is changed through FPP. Refer to the CPS help files for a description of Direct/
Talkaround Mode operation, in respect to a CPS write to the radio.
7.31.19.1
Initiating the FPP Feature
Prerequisites: Before using this feature, you should:
•
Familiarize yourself with the your radio.
•
Remove the universal connector seal or any other accessories if it is attached to the radio.
Procedure:
1 Press or to FPP.
2 Press the Menu Select button directly below FPP.
•
If you are going to program zones which are not password protected (only supported in
Federal FPP), go to
•
If you are going to program a set of zones, of which one or more are password protected, go
to
step
3. The radio displays Password.
3 Key in the password.
The radio displays Password: ********.
4 Press OK.
The radio displays Radio Param and Zn/Ch Param.
7.31.19.2
Changing Password (Optional)
Radios from the Motorola Solutions factory are provisioned with a blank password.
Prerequisites: To access the protected channels, press OK when the Enter Old Password
prompts you to change the password.
Procedure:
1 Press EDIT.
2 Enter the old password.
3 Enter the new password.
4 To accept the entry, enter the new password again.
step
4.
68012002065-HW
Chapter 7 : Advanced Features
139
Advertisement
Table of Contents
