Motorola APX 5000 3 User Manual page 15

Hide thumbs Also See for APX 5000 3:
Table of Contents

Advertisement

Never obstruct or cover the vent port, even with a label.
Ensure that no oily substances come in contact with the vent port.
(For APX 5000 R Radios Only) Your radio is designed to be submerged to a maximum depth of six
feet and maximum time of two hours. Exceeding either maximum limit may result in damage to the
radio.
(For APX 5000 R Radios Only) Elastomer seals used in portable radios age with time and
environmental exposure. To ensure the waterseal integrity of the radio, Motorola Solutions
recommends that radios be checked annually as a preventive measure. The disassembly, test, and
reassembly procedures along with necessary test equipment are available in the Service Manual.
If the radio battery contacts are exposed to water without the battery attached, dry and clean the
radio battery contacts before attaching a battery to the radio. Turn the radio over with the battery
contact facing down and shake the radio so any trapped water can escape. A short circuit of the
contacts could occur if they are not dried properly.
If the radio has been submerged in water, shake the radio to remove any water that is trapped
inside the speaker grille and microphone port. Otherwise, the water decreases the audio quality of
the radio.
If an accessory is not attached to the radio, ensure that the accessory connector cover is attached
to the radio side accessory connector.
If the radio is submerged or exposed to a high force water spray, such as from a hose, remove
the accessory or accessory connector cover immediately and ensure that no water is forced into
the accessory connector or radio interface. Rinse and dry the area and reattach the accessory or
accessory connector cover if leakage occurs.
If the radio is exposed to a corrosive environment, such as salt water or corrosive gases or liquids,
rinse, and clean the radio immediately to prevent damage to radio materials, especially plated
surfaces. Remove the battery and the antenna before cleaning.
Do not disassemble the radio as you could damage radio seals and result in leak paths into the
radio. Any radio maintenance should be performed only by a qualified radio technician.
Only Underwriter Laboratory (UL) approved service centers can open and service UL certified
radios. Opening or repairing at unauthorized locations invalidates hazardous location rating of the
radio.
Do not pound, drop, or throw the radio unnecessarily.
Turn off the radio when charging the radio using a wall-mounted charger. Otherwise, the Fall Alert
and Emergency may be accidentally triggered.
When cleaning the radio, do not use a high-pressure jet spray as this may exceed the depth
pressure and cause water to leak into the radio.
A
68012002065-HW
Chapter 1 : Read Me First
15

Advertisement

Table of Contents
loading

Table of Contents