Front Panel Programming; Initiating The Fpp Feature; Changing Password (Optional) - Motorola APX 6000 User Manual
Hide thumbs
Also See for APX 6000:
- User manual (106 pages) ,
- Quick reference card (2 pages) ,
- Quick reference card (2 pages)
Table of Contents
Advertisement
7.31.18
Front Panel Programming
You are able to customize certain feature parameters in Front Panel Programming (FPP) to enhance
the use of your radio.
The radio can be programmed in two ways:
•
Front Panel Programming (FPP) using the front panel controls of the radio.
•
Customer Programming Software (CPS), with the radio connected to a PC computer.
There are two methods to program a channel within a zone. Either:
•
Select the zone and channel through the radio interface, and then initiate the FPP feature. Or,
•
Initiate the FPP feature, and then select the zone and channel.
NOTE: When any of the Rx parameters such as Rx frequency, Rx PL, Rx DPL, and Rx NAC
is changed, FPP automatically copies these Rx parameter values to the equivalent Direct
operation (also known as Talkaround operation) parameters. If you use FPP to change the Rx
frequency to be the same as the Tx frequency and subsequently use the CPS to read then
write to the radio, Direct/Talkaround mode will operate differently from when a receive channel
parameter value is changed through FPP. Refer to the CPS help files for a description of Direct/
Talkaround Mode operation, in respect to a CPS write to the radio.
7.31.18.1
Initiating the FPP Feature
Prerequisites: Before using this feature, you should:
•
Familiarize yourself with the your radio.
•
Remove the universal connector seal or any other accessories if it is attached to the radio.
Procedure:
1 Press or to FPP.
2 Press the Menu Select button directly below FPP.
•
If you are going to program zones which are not password protected (only supported in
Federal FPP), go to
•
If you are going to program a set of zones, of which one or more are password protected, go
to
step
3. The radio displays Password.
3 Key in the password.
The radio displays Password: ********.
4 Press OK.
The radio displays Radio Param and Zn/Ch Param.
7.31.18.2
Changing Password (Optional)
Radios from the Motorola Solutions factory are provisioned with a blank password.
Prerequisites: To access the protected channels, press OK when the Enter Old Password
prompts you to change the password.
step
4.
68012001079-JW
Chapter 7 : Advanced Features
139
Advertisement
Table of Contents
