Advertisement
4. Replace the four screws (M2.5x4) that secure the left-display hinge and right-display hinge to the system board.
5. Route the WLAN-antenna cables into the routing guide underneath the fan.
6. Connect the sensor cable to the system board.
7. Connect the eDP cable to the connector on the system board and adhere the mylar.
8. Replace the screw (M2x4) that secures the eDP bracket to the system board.
Next steps
1. Install the
WLAN
card.
2. Install the
WWAN 4G card
3. Install the battery.
4. Install the
base
cover.
5. Follow the procedure in
90
Removing and installing Field Replaceable Units (FRUs)
or
WWAN 5G
card.
After working inside your
computer.
Advertisement
