Advertisement
NOTE:
The sensor board installation procedure is applicable only for Latitude 5340 laptop and not for the 2-in-1
configuration.
The following images indicate the location of the sensor board and provide a visual representation of the removal procedure.
Steps
1. Align and place the sensor board on the display assembly.
2. Connect the display to the sensor board and close the latch.
3. Route the display cable along the routing guide on the display assembly.
Next steps
1. Install the
display
panel.
2. Install the
display
bezel.
3. Install the
display
assembly.
4. Install the battery.
5. Install the
base
cover.
6. Follow the procedure in
Smart card reader
Removing the smart card reader (optional)
Prerequisites
CAUTION:
The information in this section is intended for authorized service technicians only.
1. Follow the procedure in
2. Remove the
SIM card
3. Remove the
base
cover.
4. Remove the battery.
5. Remove the
M.2 2230 solid-state
6. Remove the
WWAN 4G card
108
Removing and installing Field Replaceable Units (FRUs)
After working inside your
Before working inside your
tray.
drive.
or
WWAN 5G
card.
computer.
computer.
Advertisement
