Advertisement
Steps
1. Align the screw holes on the battery with the screw holes on the palm-rest assembly.
2. Tighten the five captive screws to secure the battery in place.
3. Connect the battery cable to the system board.
4. Adhere the mylar to the battery.
Next steps
1. Install the
base
cover.
2. Follow the procedure in
Battery cable
Removing the battery cable
Prerequisites
CAUTION:
The information in this section is intended for authorized service technicians only.
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the battery.
NOTE:
If battery is disconnected from system board for service, then there is a delay during system boot as the system
undergoes RTC battery reset.
About this task
The following images indicate the location of the battery cable and provide a visual representation of the removal procedure.
After working inside your
Before working inside your
computer.
computer.
Removing and installing Field Replaceable Units (FRUs)
65
Advertisement
