ION SYST0101CW Installation Instructions Manual page 19

6.1. Equipment Summary
Touch EQUIPMENT SUMMARY to show indoor unit type and model number, outdoor unit
type (and model number if a 2-stage unit), filter type, any accessories that are installed, and the
number of zones in the system. To return to the previous screen, touch BACK. To exit the
Service menus, touch DONE.
6.2. Installation
Touch INSTALLATION to perform the start-up process in order to learn all equipment in
system. Select FULL INSTALLATION, then touch NEXT to initiate the process.
Touch Airflow Verification Test to perform a duct assessment. This can be done if duct
modifications have been made since installation of the Ion System Control. Duct assessment
can be performed without performing a full system install.
NOTE: This feature is only available with specific ICP communicating indoor units. See the
Ion System Control Product Data for compatible units and more information.
6.3. Set up
NOTE: Depending upon the equipment installed, the following options will be displayed. See
the ICP communicating HVAC equipment Installation Instructions for more details, as
provided.
• Indoor:
– Furnace
– Fan coil
• Outdoor:
– AC/Heat pump
Once the equipment has been selected, the appropriate menus will be displayed.
6.3.1. Thermostat
First touch SETUP, then touch THERMOSTAT to set up the parameters for the Ion System
Control.
19
A13130