Operating Materials - J. D. NEUHAUS PROFI 6 TI Customer's Operating And Assembly Instructions

3.9. Operating materials

CAUTION
Danger of skin irritation
Oils and greases may cause skin irritation.
Wear protective gloves
NOTICE
Do not mix synthetic oils or greases with mineral
oils or greases, as the properties may deterio-
rate. Also never mix different types of lubricating
grease within the synthetic or mineral lubricant
groups. When operating with oilers, synthetic
lubricants may never be used. Alcohols are not
permitted as de-icing agents.
The following operating materials and lubricants
are intended for normal environmental influences.
In the event of environmental influences that pro-
mote wear, please contact J.D. Neuhaus to obtain
appropriate information.
Doc.-No.: VA057988-10-OM-EN-0821-62-1
P
RODUCT INFORMATION
Application area
Motor lubrication
Engine lubrication for
operation with oiler
Chain lubrication
Motor corrosion pro-
tection (not applicable
if using the JDN high
performance grease)
Engine cleaning (not
applicable if using the
JDN high performance
grease)
Lubrication for bearings
and gearbox (also for
open gears)
Operating material
JDN high performance
grease, item no. 11904
(250ml)
Air lubricator "D", kine-
matic viscosity about
mm
30 (cSt) at 40 C,
s
possibly with anti-icing
agent
Chain oil or vehi-
cle motor oil, kine-
matic viscosity about
mm
150 (cSt) at 40 C,
s
or special lubricant
from J.D. Neuhaus.
In areas with extreme
corrosion potential,
such as offshore, a
lubricant with a particu-
larly powerful corrosion
protection is to be
used.
Non-gumming preser-
vative oil with corre-
sponding effective
duration
Pure petroleum
Lithium-saponified
grease, worked pen-
etration 265-295
(0,1mm), base oil
mm
viscosity: 190 (cSt)
s
at 40 C, dropping point:
180 C,
Application temper-
atures: -20 C to +
120 C,
Designation according
to DIN 51825: KP2K-
20, active ingredients:
EP additives (to reduce
wear) and ageing pro-
tection; water-resistant
and anti-corrosive
Page 21 of 62