Language - Sub Menu - Digital View AC-1024 Instructions Manual

Language – sub menu
English
Italiano
Francais
Espanol
Svenska
Deutsche
Nederlands
Back to previous menu
OSD functions – Video input
Volume (note 3)
Brightness
Contrast
Tuning
Auto setup
FRC
PC or Video
Color
Tint
Image vertical position
Image horizontal position
Image size – horizontal
Image expansion
System info 4
Exit menu
Extended menu 4
Items marked
Note 3:
The OSD settings chosen will be stored in memory. The OSD menu can be cleared
from the screen by pressing the menu button otherwise it will automatically clear after a
few seconds (time-out period) of non-use.
(Note: Instructions for remote control are not provided as this will depend on the
handset provided)
Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com.
Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from
Select English display
Select Italian display
Select French display
Select Spanish display
Select Swedish display
Select Dutch display
Select Netherlands display
Go back to previous menu
:
Increase/decrease sound output volume if Audio board is installed
Increase/decrease panel brightness level
Increase/decrease panel contrast level
Fine tune the data sampling position (adjust display quality)
Auto setting the display, e.g. positions, image size, tuning, etc.
Frame rate control (increase number of colors on a lower bit panel)
Set which input signal (PC or Video) has priority if both are
connected and active.
Adjust color level of video signal
Adjust tint level (functions in NTSC mode only)
Adjust the image vertical position (up & down)
Adjust the image horizontal position (left & right)
Adjust the image horizontal size
Adjust vertical image size (ON = 10% expansion)
Shows system information by turn on the system info submenu
Turn off the OSD menu
Turn on the extended menu
4
have sub menus.
The Volume option will appear if dip-switch (SW1) position #4 is ON.
This option will not appear if SW1 position #4 is OFF. Restart the board
is required after setting of SW1 to enable the setting.
12