HIKVISION D0T POC C Series User Manual page 8

Check whether the power supply is matched with

your power output to avoid the damage.
Make sure the wall is strong enough to withstand

three times the weight of the camera, and the
mount.
If the wall is cement, insert expansion bolts before

installing the camera. If the wall is wooden, use
self-tapping screws to secure the camera.
If the product does not function properly, contact

your dealer or the nearest service center. DO NOT
disassemble the camera for repair or maintenance by
yourself.
2.1 Installation of Type I Camera
2.1.1 Ceiling/Wall Mounting
Before you start:
The installation of ceiling mounting and wall mounting
are similar. Following takes ceiling mounting as an
example.
Steps:
1. Drill the screw holes and the cable hole (optional)
on the ceiling.
Note:
Drill the cable hole, when adopting the ceiling outlet
to route the cable.
2. Route the cables through the cable hole, or the side
opening.
3. Attach the bracket to the ceiling, and secure the
camera with supplied screws.
Wooden Wall/Ceiling
Figure 2-1 Install Camera on Ceiling
Note:
The supplied screw package contains self-tapping

screws, and expansion bolts.
For cement wall/ceiling, expansion bolts are

required to fix the camera. For wooden
wall/ceiling, self-tapping screws are required.
4. Connect the corresponding power cord, and video
cable.
5. Power on the camera to check if the image on the
monitor is gotten from the optimum angle. If not,
adjust the camera according to the figure below.
Rotation Position
[0° to 360°]
1). Loosen the trim ring to adjust the pan position
[0° to 360°].
2). Loosen screw A to adjust the tilt position [0° to
180°].
PA4 × 25 Screws
Figure 2-2 3-Axis Adjustment
Expansion Bolts
PA4 × 25 Screws
Cement Wall/Ceiling
Pan Position
[0° to 360°]
Tilt Position
[0° to 180°]
Screw A
Screw B
Trim Ring