HIKVISION D0T POC C Series User Manual page 6

Warnings Follow
these safeguards to
prevent serious injury
or death.
Warnings
In the use of the device, you must be in strict

compliance with the electrical safety regulations of
the nation and region.
Input voltage should meet both the SELV (Safety Extra

Low Voltage) and the Limited Power Source with 12
VDC according to the IEC60950-1 standard. Refer to
technical specifications for detailed information.
Do not connect multiple devices to one power

adapter to avoid over-heating or a fire hazard caused
by overload.
Make sure that the plug is firmly connected to the

power socket.
Make sure that the device is firmly fixed if wall

mounting or ceiling mounting is adopted.
If smoke, odor or noise rise from the device, turn off

the power at once and unplug the power cord, and
then contact the service center.
Never attempt to disassemble the camera by

unprofessional personal.
Cautions
Do not drop the camera or subject it to physical

shock.
Do not touch senor modules with fingers.

Do not place the camera in extremely hot, cold (the

operating temperature shall be -40°C to 60°C), dusty
or damp locations, and do not expose it to high
electromagnetic radiation.
If cleaning is necessary, use clean cloth with a bit of

ethanol and wipe it gently.
Do not aim the camera at the sun or extra bright

places.
The sensor may be burned out by a laser beam, so

when any laser equipment is in using, make sure that
the surface of sensor will not be exposed to the laser
beam.
Do not expose the device to high electromagnetic

radiation or extremely hot, cold, dusty or damp
environment.
To avoid heat accumulation, good ventilation is

required for the operating environment.
Keep the camera away from liquid while in use for

non-water-proof device.
While in delivery, the camera shall be packed in its

original packing, or packing of the same texture.
1 Introduction
1.1 Product Features
The main features are as follows:
Cautions Follow these
precautions to prevent
potential injury or
material damage.