HIKVISION D0T POC C Series User Manual page 13

2.3 Installation of Type III Camera
2.3.1 Ceiling Mounting
Steps:
1. Disassemble the camera by rotating the camera to
align the notch to one of the marks.
2. Pry the mounting base by using a flat object, e.g., a
coin.
3. Drill the screw holes and the cable hole (optional)
on the ceiling.
Note:
Drill the cable hole, when adopting the ceiling outlet
to route the cable.
4. Attach the mounting base to the ceiling, and secure
it with supplied screws. For cement ceiling, you
need to mount the expansion bolts at first.
Wooden Wall/Ceiling
Figure 2-18 Install Mounting Base to Ceiling
Note:
The supplied screw package contains self-tapping

screws, and expansion bolts.
For cement wall/ceiling, expansion bolts are

required to fix the camera. For wooden
wall/ceiling, self-tapping screws are required.
5. Route the cables through the cable hole, or the side
opening.
6. Install the camera back to the mounting base and
secure it.
Figure 2-19 Install the Camera Back
7. Connect the corresponding power cord, and video
cable.
8. Power on the camera to check whether the image
on the monitor is gotten from the optimum angle. If
not, adjust the camera according to the figure below
to get an optimum angle.
Figure 2-17 Disassemble Camera
PA4 × 25 Screws
PA4 × 25 Screws
Cement Wall/Ceiling
Expansion Bolts