Installing Spikes - REVELL Ultima Salon User Manual

INSTALLING SPIKES

After choosing a final placement, add the spikes (and covers, if
desired) by performing the following steps:
1. Remove spike feet and locking rings from the plastic bags.
2. Enlist the aid of friend to tilt a SALON to one side and start a
pair of spikes, as shown in Figure 7. Use caution to avoid
touching the front tweeter and midrange. The tip of the spike
should extend about 1
Locking
Ring
Spike
Cover
(for hardwood
or tile floor)
3. Assemble and tighten locking rings onto the front spikes.
4. Tilt the SALON in the other direction and install the other pair
of spikes in the same manner.
NOTE: If the speaker is to be used on a hardwood or tile floor, use
supplied spike covers. Further adjustment of spike may be necessary
due to uneven floors.
5. Repeat steps 1 through 4 for the other SALON.
10 SALON
Owner's Manual
1 ⁄ " from the bottom of the cabinet.
2
1 1 "
⁄
2
(Optional) Use Covers For
Hardwood Or Tile Floor
Figure 7. Tilting a SALON
and installing a pair of spikes.