REVELL Ultima Salon User Manual page 7

Figure 4. A SALON with its
inner packing materials.
Figure 5. Installing the
optional top grille.
Hardware
Top End Pad
Foam Strip
(1of 4)
Bottom
Rear End Pad
7. Remove top end pad, fabric sock, and plastic bag from the grille,
using caution to avoid touching the front tweeter or midrange.
8. Remove enclosed hardware and optional top grille (if present)
from recessed pockets in the top end pad. Install the top grille,
as shown in Figure 5.
Magnets
(in wood)
Top
Grille
9. Repeat steps 1 through 8 for the other SALON.
NOTE: We recommend installing spikes after determining final
speaker placement (see discussion starting on next page).
After unpacking both units, carefully inspect each one for possible
damage due to shipping. If you discover any damage, immediately
contact your Revel dealer for further assistance. To move an
unpacked SALON (e.g., when experimenting with placement),
rock it side-to-side into place, using caution to avoid touching the
front tweeter and midrange.
Keep all packing materials for future shipping. In the unlikely
event a product will need repair, Revel will only accept a unit in its
original shipping carton. Using any other packing materials may
result in damage to the product and is not covered by the warranty.
See Service Information on page 23 for additional details.
Top Grille
(if present)
Bottom
Front End Pad
SALON 7
Owner's Manual