Table of Contents
Advertisement
ADJUSTABLE SPIKES
When the C52 is shipped, spikes are attached to the left pad identified in Figure 2. For optimal
sound quality, the spikes can be positioned in the threaded inserts on the bottom of the cabinet.
Both 1.5-inch (38mm) and 2.25-inch (57mm) adjustable spikes are included, allowing for
achievement of the proper tilt angle when the C52 is placed on top of a video monitor as
shown in Figure 6 or a shelf. For best results, the C52 should be tilted so the front of the speaker
is facing directly toward the listener's ears.
To install and position the spikes:
1. Place the C52 on its side on a soft towel
or carpeted floor.
2. Select the appropriate set of spikes to
create a tilt angle that aligns the tweeter
with the listener's ears.
•
Select the 1.5-inch spikes for a
slight downward tilt as shown on
the left side of Figure 8 (below).
•
Select the 2.25-inch spikes for a
greater tilt as shown on the right
side of Figure 8 (below). These
spikes are required for higher
loudspeaker placement.
3. Locate the two threaded inserts on the
bottom of the cabinet. These inserts are
identified on the left side of Figure 9
(next page).
4. Rotate the first spike clockwise, spike
end first, to attach it to the threaded
insert.
Figure 8: Tilting the C52
REVEL Performa C52
12
OWNER'S MANUAL
5. Repeat step 4 using the other spike and
6. Place the protective caps over the
7. When both spikes have been inserted,
Rear of C52
1.5-inch Spike
threaded insert. Make sure the two
spikes are evenly threaded to achieve a
level balance.
round end of the spikes as shown on
the right side of Figure 9 (next page) to
prevent the spikes from scratching the
mounting surface.
stand the C52 in the upright position.
If needed, adjust the spikes to achieve
a level balance.
Rear of C52
2.25-inch Spike
Advertisement
Table of Contents
