Installing Spikes - REVELL Performa C50 User Manual

INSTALLING SPIKES

If desired, you can add spikes to the REVEL PERFORMA C50
loudspeaker as follows:
1. Remove the spike feet, lock nuts, and wrench from the plastic bag.
2. Lay the REVEL PERFORMA C50 loudspeaker on its top on a
carpeted area or soft towel. Use caution to avoid touching the
transducers and grille. Remove the black screws that serve as
glides on the three feet and store them for future use. Start a set
of spikes, as shown in Figure 8. Be sure to thread each spike the
same amount to achieve a level placement.
NOTE: If you want to place the loudspeaker on a hardwood or tile
floor, or on a large-screen television set, use the round ends with
optional supplied covers. Further adjustment of each spike may be
necessary due to uneven floors.
Carpeted Area or Soft Towel
Foot
Lock Nut
Spike
7⁄ 8" max.
round end
Slip Dome
or
Cover Cover
HARD FLOOR OR TV
3. (Optional) To tilt the REVEL PERFORMA C50 loudspeaker
down (or up) so that it is on-axis with the listener(s), perform
the following:
• For a downward tilt, adjust the two front spikes for decreased
extension and the rear center spike for increased extension to
achieve the amount of tilt you desire.
• For a upward tilt, adjust the two front spikes for increased
extension and the rear center spike for decreased extension to
achieve the amount of tilt you desire.
4. Using the supplied wrench, tighten a lock nut onto each spike.
REVEL PERFORMA C50
10
Owner's Manual
REVEL PERFORMA C50
(on its top)
Foot
Lock Nut
Spike
1 1⁄ 8" max.
spike end
CARPETED FLOOR
Figure 8. Installing a
set of spikes on a
REVEL PERFORMA C50
loudspeaker.