Figure 4. Installing the base
onto the pedestal.
Figure 5. Installing spikes.
INSTALLING STANDS (OPTIONAL)
1. Unpack all stand boxes. Place a pedestal, base, and top plate on
a soft surface (e.g, rug or soft cloth).
2. Using a Phillips screwdriver, install a base to a pedestal with five
long screws, as shown in Figure 4.
Base
Pedestal
3. Thread four spikes about halfway into the base and tighten each
one with a locking ring, as shown in Figure 5.
(4) Covers*
(optional for hardwood
or tile floors)
(4) Spikes
(4) Locking
(Optional) Use Covers*
For Hard Floors
*NOTE: Apply a small bead of supplied
silicone adhesive into each cover and
fasten onto each spike. Wait 20 minutes
for silicone to set.
(5) Long Screws
(Start All Screws
Before Tightening)
Rings
continued on next page...
REVEL ULTIMA GEM
Owner's Manual
7