Cloning Radios Using The Multi-Unit Charger - Motorola CLP Series User Manual

68012000044-ED
Chapter 5 : Radio Cloning
2 Plug one side of the cloning cable micro USB to one SUC and plug the other end to the second
SUC.
NOTE:
During the cloning process, no power is applied to the SUC. The batteries cannot be
charged. A data communication is established between the two radios.
3 Turn on the target radio and place it into one of the SUC.
4 To power the source radio, press and hold the PTT button and the - button simultaneously while
turning on the radio until you hear the cloning tone and the yellow LED double blinks on the
smart status glow.
5 To start the cloning process, place the source radio in its SUC with an audio accessory, then
press and release the Menu button.
If successful, the source radio sounds a good key chirp tone.
If unsuccessful, the source radio sounds bonk tone.
The tone sounds for no more than five seconds.
6 Turn the radios off and on to bring the radios to the user mode by exiting the clone mode when
the cloning process is completed.
5.3

Cloning Radios using the Multi-Unit Charger

Prerequisites: Cloning radios using Multi-Unit Charger (MUC) Kit part number HKPN4007_ (optional
accessory)
Procedure:
1 To put the source radio into clone mode, press and hold the source radio PTT button and the -
button simultaneously while turning on the radio until you hear the cloning tone and the yellow
LED double blinks on the smart status glow ring.
2 Place the source radio into one of the charging pockets that has the CLONE label.
3 Turn on the target radio and place it in the pairing charging pocket that has the CLONE label
and start the cloning process.
4 To start the cloning process, press the Menu button on the source radio.
The source radio generates the start clone tone.
5 To activate the radio, turn off and on the radios when cloning process is completed.
6 To clone another radio, repeat
7 To exit clone mode on the source radio, turn off the radio.
32
step 3 to step 5.