Talk Range; Menu Setting; Operations Using Menu Settings - Motorola CLP Series User Manual

68012000044-ED
Chapter 2 : Getting Started
2 Speak clearly into the microphone on the audio accessory.
3 Release the PTT button to listen.
4 To receive calls, listen through the earpiece and press the PTT button to respond.
NOTE: The CLP Series radios always require the use of an audio accessory with
microphone and speaker.
2.7.1

Talk Range

Table 2: Talk Range
Application
Unit to Unit
With Repeater
2.8

Menu Setting

Procedure:
1 To navigate through the menu settings, press the Menu button.
2 To exit the menu, short press the PTT button or wait for three seconds.
NOTE: Voice Assisted Operation feature may not be available on certain previous
shipping radios.
2.8.1

Operations Using Menu Settings

This section explains operations using the menu settings.
NOTE:
It is not necessary to wait for the voice prompt to be completed before continuing with pressing
the next button.
If you are in the menu mode, short press PTT or wait 3 seconds to exit the menu.
The Voice Assisted Operation feature may not be available on certain previous shipping radios.
For single channel models, monitor, scan mode, and call tone are supported. Single channel
models support scan mode when you enable Dynamic Talkaround Scan on a repeater
channel through the Customer Programming Software (CPS).
Procedure:
1 Changing channel:
a Press Menu button to navigate to Channel.
b Press the + or the – button to change channel.
2 Entering Monitor Mode:
a Press Menu button to navigate to Monitor.
b Press the + to activate or the – button to deactivate monitor.
3 Entering Scan Mode:
16
Industrial (Inside steel/con-
crete industrial buildings)
2
Up to 100,000 ft (9,200 m
2
Up to 250,000 ft (23,200 m
Multi-Level (Inside multi-lev-
el buildings)
2
) Up to 10 floors
2
) Up to 20 floors