System Optimization - REVELL Performa F50 Owner's Manual

SYSTEM OPTIMIZATION

1. After connecting the F50a loudspeakers, initially set the
TWEETER LEVEL CONTROL on both rear panels to the
"0" position, as shown in Figure 12 (below).
2. Turn on the system power and play a favorite piece of music.
Slowly increase the volume to a comfortable level and listen
from your main listening position. If desired, experiment with
placement (see page 8) to achieve the best overall tonal balance,
image specificity, and spaciousness.
3. You may also wish to further adjust each TWEETER LEVEL
CONTROL. Varying the control will change the high frequency
balance and timbre. Differences in room acoustics often demand
different level control settings.
NOTE: Set the controls the same on both left and right channels.
REVEL
PERFORMA
F50a
Rear
-.5 0 +.5
-1 +1
Revel Front Tweeter Level (dB)
Northridge, California
Made in U.S.A.
Remove straps
for bi-wire
Serial Number Install straps for or bi-amp
xxxx
single-wire operation
Install straps for
single-wire operation
Low Frequency Input High Frequency Input
REVEL PERFORMA F50a
18
Owner's Manual
Set Tweeter
Level Control
To "0"
0 +.5
-.5
-1 +1
Revel Front Tweeter Level (dB)
Northridge, California
Made in U.S.A.
Remove straps
for bi-wire
Serial Number or bi-amp
Install straps for
xxxx
single-wire operation
Install straps for
single-wire operation
Low Frequency Input High Frequency Input
Connector
Panel
Figure 12. The location of the
F50a TWEETER LEVEL
CONTROL and its initial
setting for system optimization.