System Optimization - REVELL Ultima Voice User Manual

SYSTEM OPTIMIZATION

1. After connecting the VOICE speaker, initially set the HIGH
FREQUENCY LEVEL control on the rear panel to the "0"
position (see Figure 10).
VOICE Rear
Revel Corporation Install straps for Note:
Chatsworth, California single-wired operation Remove straps
Made in U.S.A. or bi-amplified for bi-wired
operation
On Top Of
Monitor 0
Flush Stand -.5 +.5
Mounted Mounted Install straps for -1 +1
single-wired operation
Placement High Frequency
Compensation Low Frequency Input High Frequency Input
(See Owner's Manual) Level (dB)
Serial Number
Bass
Increases
On Top Of
Monitor
Flush Stand
Mounted Mounted
Low Frequency Input
Set Placement Compensation Control
To Match VOICE Placement
2. Intially set the PLACEMENT COMPENSATION control (see
Figure 10) to match the application as follows:
• Use the Flush Mounted setting when the VOICE is flush-
mounted in a wall or custom-built "media wall", or is placed
on a bookshelf.
• Use the Top of Monitor setting when the VOICE is placed
on top of a rear projection monitor.
• Use the Stand Mounted setting when the VOICE is placed
on its (optional) VOICE Pedestal.
3. Turn on the system power and play a variety of material. Slowly
increase the volume to a comfortable level and listen from your
main listening position. Be sure to set your multi-channel con-
troller to a mode that utilizes the center channel. If the VOICE
is used in a home theater system, listen to well-recorded dialog
from more than one film, as the sound quality can vary greatly.
VOICE Speaker
12
Owner's Manual
Set High-Frequency
Level Control To "0"
Install straps for Note:
Remove straps
single-wired operation
for bi-wired
or bi-amplified
operation
Install straps for
single-wired operation
High Frequency Input
Connector Panel
Figure 10. The VOICE level
and placement control locations
and initial settings.
0
-.5 +.5
-1 +1
High Frequency
Level (dB)