System Optimization - REVELL Ultima Studio User Manual

Figure 13. REVEL ULTIMA
STUDIO level control locations
and initial settings.

SYSTEM OPTIMIZATION

1. After connecting the REVEL ULTIMA STUDIO loudspeakers,
initially set both HIGH FREQUENCY LEVEL controls on
both rear panels to the "0" position, as shown in Figure 13.
REVEL
ULTIMA
STUDIO
Rear
-.5 0 +.5 -3 0
-1 +1 Off
Remove straps
for bi-wire
or bi-amp
Front Tweeter Level Rear Tweeter Level
Low Frequency Input High Frequency Input
Serial Number
xxxx
Revel Corporation
Northridge, California
Made in U.S.A.
2. Turn on the system power and play a favorite piece of music.
Slowly increase the volume to a comfortable level and listen
from your main listening position. If desired, experiment with
placement (see page 8) to achieve the best overall tonal balance,
image specificity, and spaciousness.
3. You may also wish to further adjust the HIGH FREQUENCY
LEVEL controls (see Figure 13) for both front and rear tweet-
ers to achieve the most natural sound in your room. Varying
the FRONT control will change the high frequency balance
and timbre. Varying the REAR control will mainly affect "air"
and spaciousness. Do not hesitate to experiment with changes
to the front and rear high frequency level controls. Differences
in room acoustics often demand different level control settings.
NOTE: Be certain the corresponding controls are set the same on
both left and right channels.
Set Both Tweeter
Level Controls
To "0"
0 0
-.5 +.5 -3
Off
-1 +1
Remove straps
for bi-wire
or bi-amp
Front Tweeter Level Rear Tweeter Level
Low Frequency Input High Frequency Input
Revel Corporation
Northridge, California
Made in U.S.A.
Connector
Panel
REVEL ULTIMA STUDIO
Owner's Manual
17