Table of Contents
Advertisement
Installation & Setup (cont.)
Procedure
1. Remove the outer packaging (cardboard and bubble wrap or
Styrofoam corner and clear plastic). See fig. 1.
2. With an adjustable wrench, remove all shipping bolts securing
the wood skid to the bottom of the appliance. See fig. 2.
Move the appliance as close as possible to
NOTICE ›
the final location before removing the wooden skid. Your
appliance may require removing the front and/or rear grill/
cover to access the shipping bolts.
3. If leveling legs or castors will not be used, remove the cabinet
from the wood skid and set the skid aside.
If leveling legs or castors will be used, rotate the cabinet on
the skid (see fig. 3) and see leveling leg or castor installation
instructions (pg. 12).
NOTICE ›
DO NOT lift the appliance by the counter tops,
doors, drawers, or grills.
TEC_TM_184 | REV. B | EN
CVM
Fig. 1. Remove the exterior packaging.
Fig. 2. Example of shipping bolt locations.
Fig. 3. Rotate the appliance on the skid. When lifting the appliance, do not use
countertops, doors/drawers, or grills as lifting points.
07/25/2023
truemfg.com
Page 11 of 32
Advertisement
Table of Contents
