RADEMACHER RolloTron Swivel Winder Comfort 1500 Operating And Assembly Manual page 52

i
20. What to do if... ?
Fault
... the roller shutters stop during downward travel?
... the temperature display appears and the
RolloTron Swivel Winder Comfort fails to operate
in either direction?
... the RolloTron Swivel Winder Comfort fails to
react properly either manually or automatically?
52
Possible cause / solution
a) The roller shutters may have hit an obstacle.
Move the roller shutters back up and remove the obstacle.
b) Slats have shifted out of alignment.
If possible, move the roller shutters back up and realign the slats.
c) The roller shutters scrape against the window frame or inside the
roller shutter box due to the lack of a pinch roller or insulation
material may have come free and is jamming the roller shutters.
Open the roller shutter box and rectify the fault. Lubricate any
stiff areas with gliding wax.
d) The roller shutters are too light.
Increase the weight of the roller shutters by, for example, adding
a piece of flat steel to the bottom slat.
The maximum running time of the drive has been exceeded, see
page 6/18.
The motor is too hot. The belt winder will be fully operational
again in approx. 1 hour.
The RolloTron Swivel Winder Comfort is no longer operational. Carry
out a software reset in accordance with the instructions on page
47 and test the RolloTron Swivel Winder Comfort using the default
factory settings.
EN