Making Dual Operator Cc And Cv Weld Connections W/ Separate Work Cables - Miller Big Blue Duo Air Pak 800X Owner's Manual

5-12. Making Dual Operator CC And CV Weld Connections w/ Separate Work Cables

.
Welder A (Left) Side
2
! Stop engine.
NOTICE − Do not exceed machine duty
cycle.
.
Use Dual Operator mode for CC and
CV welding (see Section 6-2).
See Section 5-15 for proper cable size.
1 Electrode Holder Cable
2 Wire Feeder Cable
3 Work Cables
OM-267603 Page 32
.
Complete Parts List available at www.MillerWelds.com
Direct Current Electrode Positive
(DCEP) connections are shown.
Welder B (Right) Side
1
For Stick/TIG welding Direct Current Elec-
trode Positive (DCEP), connect work
cable to Negative (−) terminal and elec-
trode holder cable to Positive (+) terminal.
For Stick/TIG Direct Current Electrode
Negative (DCEN), connect work cable to
Positive (+) terminal and electrode holder
cable to Negative (−) terminal.
.
Be sure Process Selector switches
are set correctly. See Section 6-4.
3
3
For MIG and FCAW welding Direct Current
Electrode Positive (DCEP), connect work
cable to Negative (−) terminal and wire
feeder cable to Positive (+) terminal.
For MIG and FCAW Direct Current Elec-
trode Negative (DCEN), connect work
cable to Positive (+) terminal and wire feed-
er cable to Negative (−) terminal.
.
Be sure Process Selector switches
are set correctly. See Section 6-4.
Tools Needed:
3/4 in.
258 836