Making Dual Operator Mode Cc Weld Connections W/ Common Work Cable - Miller Big Blue Duo Air Pak 800X Owner's Manual

5-9. Making Dual Operator Mode CC Weld Connections w/ Common Work Cable

.
Welder A (Left) Side
1
! Stop engine.
! Failure to properly size and connect
weld cables may cause excessive
heat and start a fire, or damage your
machine.
NOTICE − When making weld connections
with a common work cable, connect weld
cable of adequate size between Negative
(−) weld output terminals, and connect a
single weld cable of adequate size from
Welder B (right) Negative (−) terminal to the
workpiece.
NOTICE − When using these connections
as a common work terminal, all connec-
tions must be of the same polarity.
NOTICE − For common work connection,
.
Complete Parts List available at www.MillerWelds.com
Direct Current Electrode Positive
(DCEP) connections are shown.
Welder B (Right) Side
2
work cable must be able to carry combined
weld output of both modules (see Section
5-15 for proper cable size).
NOTICE − Do not exceed machine duty
cycle.
.
Use Dual Operator mode for CC and
CV welding (see Section 6-2).
1 Electrode Holder Cables
2 Work Jumper Cable
3 Common Work Cable
For Stick/TIG welding Direct Current Elec-
trode Positive (DCEP), connect common
work cable and work jumper cable to Weld-
er B (right) Negative (−) terminal. Connect
1
3
other end of work jumper cable to Welder A
(left) Negative (−) terminal.
Connect electrode holder cables to Positive
(+) terminals.
For Stick/TIG Direct Current Electrode
Negative (DCEN), connect common work
cable and work jumper cable to Welder B
(right) Positive (+) terminal. Connect other
end of work jumper cable to Welder A (left)
Positive (+) terminal.
Connect electrode holder cables to Nega-
tive (−) terminals.
.
Be sure Process Selector switches are
set correctly. See Section 6-4.
Tools Needed:
3/4 in.
258 836
OM-267603 Page 29