Autopilot Operation - Raymarine ST3000 Owner's Handbook Manual

58
Heading alignment
1. Steer your boat on a straight course, then use -1 and +1 to adjust
2. Exit compass linearization and heading alignment and store the
Note: For installations where an ST50 or ST30 Steering Compass
instrument is connected to the SeaTalk bus, and the Steering
Compass has a fluxgate transducer connected, it is only necessary to
carry out the auto deviation correction on the Steering Compass
Instrument (refer to Steering Compass handbook instructions).
Further adjustments to heading alignment
If the heading alignment requires further adjustment after the initial
sea trial:
1. Enter Compass Deviation Correction by pressing STANDBY for
2. Press AUTO to skip Deviation Correction and proceed to Heading
3. Adjust the heading as described above.
4. Press and hold STANDBY for 1 second to save changes and exit.

Autopilot operation

Having calibrated the compass, the following procedure is
recommended to familiarize yourself with autopilot operation:
1. Steer onto a compass heading and hold the course steady.
2. Engage the wheel drive clutch by rotating the clutch lever
3. Press AUTO to lock onto the current heading. The wheel pilot
4. Use the course change keys to alter course to port or starboard in
5. Press STANDBY and disengage the clutch lever to return to hand
ST3000 Wheel Drive Autopilot - Owner's Handbook
the displayed autopilot heading until it agrees with the boat's
steering compass or a known transit bearing.
compass correction/alignment values as follows:
press and hold STANDBY for 1 second until the pilot beeps
•
or, to exit without saving any new settings, press STANDBY
•
momentarily
1 second.
Alignment.
clockwise.
should achieve a constant heading in calm sea conditions.
multiples of 1° and 10°.
steering.