Raymarine ST3000 Owner's Handbook Manual page 51

46
4. When you have determined the correct position for the clevis,
5. Remove the drive unit and draw around the inside of the
6. Drill two 8 mm (
Note: Before drilling the holes, check that you have access to the
other side of the mounting wall to attach the nuts!
ST3000 Wheel Drive Autopilot - Owner's Handbook
carefully draw around its base.
elongated fixing holes on the clevis.
5
/ in) clearance holes for the clevis fixing bolts
16
at the lower end of each elongated hole position. This allows the
belt to be subsequently tightened if necessary.
D5639-1
D5640-1
D5653-1