Raymarine ST3000 Owner's Handbook Manual page 50

Chapter 4: Installing the Wheel Pilot
Attaching the mounting clevis
1. Fit the mounting clevis to the drive unit using the pin provided.
2. Rotate the clutch lever fully clockwise against its stop (i.e. to the
3. Move the clevis down against the side wall until the belt is just
Then loop the belt drive over the drum and the drive sprocket.
'tight belt' position) and then offer the clevis against the vertical
side-wall.
taut. Then adjust the fore-and-aft position of the clevis until the
belt lies parallel to the wheel. To help check if the belt is running
parallel, use a long straight edge such as a sail batten.
45
Radial offset
D5637-1
D5638-1