42
Mounting the socket
To mount the SeaTalk socket:
1. Fix the template (supplied at the end of the handbook) onto the
2. Carefully drill the 18 mm (
3. Fit the plug cap to the socket body.
4. Locate the O-ring seal into the groove between the plug cap and
5. Cut and strip back the power cables and SeaTalk cables (if fitted).
6. Thread both cables through the bulkhead hole and connect to the
7. Attach the socket to the bulkhead using the two self tapping
8. Secure the cables to the bulkhead.
ST3000 Wheel Drive Autopilot - Owner's Handbook
bulkhead at the selected socket location
3
(
/
in) pilot holes, then remove the template.
32
socket body.
relevant pins on the socket.
screws supplied.
To power supply
23
/
in) clearance hole and 2.4 mm
32
To SeaTalk
Screen
(Sea Talk 0 V)
Black
(Supply 0 V)
Pin
Identification
Stripes
Red
(+12 V)
Yellow
(Sea Talk
Data)
D5634-1