Switching Display Illumination On And Off - Raymarine ST3000 Owner's Handbook Manual

16

2.3 Switching display illumination on and off

You can switch the display illumination on and off when the wheel
pilot is in Standby mode:
•
•
From Standby mode
Note: The wheel pilot normally powers-up with the illumination
switched on ( L1 ).
If other SeaTalk instruments or autopilot control units are connected
via SeaTalk, you can also control the wheel pilot's illumination from
these units.
ST3000 Wheel Drive Autopilot - Owner's Handbook
from Standby mode, press -1 and +1 together to switch the
illumination between on ( L1 ) and off ( L0 )
to return to the previous mode either wait 10 seconds or press the
appropriate mode key
and
D5620-1