Remote Start Diagnostics; Alarm Diagnostics - Fortin ORBITF2400 Quick Installation Manual

All-in-one data interface remote starter / alarm

Hide thumbs

Table of Contents

TO ENABLE COLD START MODE

Press and release the

within 12 seconds simultaneously press

and and hold the

for 1 second. The remote's Green LED will

flash and beep once to confirm. The parking

lights will flash once.

DISARM / ENTER / EXIT VALET MODE

System armed

to disarm

the system

: DEL flash

to enter and

System

exit valet

disarmed :

mode

LED is OFF

REMOTE START DIAGNOSTICS

Parking Lights flashes (before starting) :

Ready mode disabled

Valet mode activated (The LED is on)

Hood open

WARNING

NOTICE

The manufacturer will accept no responsibility for any electrical damage resulting from improper installation of the product, including either damage to the vehicle

itself or to the remote-starter module. This module must be installed by a certified technician including all of the supplied safety devices. Please note that this guide

has been written for trained professional technicians, a certain level of skills and knowledge is therefore assumed. Please review the Installation Guide carefully before

beginning any work.

WARNING

By default this system is setup for vehicles with a manual transmission. For vehicles with an automatic transmission the safety wire loop on the main unit must

be cut. Before proceeding to the installation, make sure that the vehicle does not attempt to start when the when the vehicle is in the "drive" or "reverse" position. If an

automatic transmission vehicle starts when the transmission is in gear, ensure that the safety wire loop on the unit is not cut. Once the safety wire loop is cut, the system

is considered an automatic transmission remote-starter indefinitely. Once a loop is cut all warranties, guaranties, and liability is immediately void if the unit is install on

a manual transmission vehicle.Neither the manufacturer or distributor of this module is responsible of damages of any kind indirectly or directly caused by this module,

except for the replacement of this module in case of manufacturing defects. This module must be install by qualified technician. This instruction guide may change

without notice. To download the installation guide, user guide, or the latest quick installation guide, visit: WWW.FORTIN.CA

FUNCTION

button,

LOCK

START

and

buttons

STEP 1

Insert the key

and turn it to the

ignition (ON/RUN)

position.