Advertisement
DISARM / ENTER / EXIT VALET MODE
System armed
to disarm
the system
: DEL flash
to enter and
System
exit valet
disarmed :
mode
LED is OFF
REMOTE START DIAGNOSTICS
Parking Lights flashes (before starting) :
3x
Ready mode disabled
4x
Valet mode activated (The LED is on)
5x
Hood open
WARNING
NOTICE
The manufacturer will accept no responsibility for any electrical damage resulting from improper installation of the product, including either damage to the vehicle
itself or to the remote-starter module. This module must be installed by a certified technician including all of the supplied safety devices. Please note that this guide
has been written for trained professional technicians, a certain level of skills and knowledge is therefore assumed. Please review the Installation Guide carefully before
beginning any work.
WARNING
By default this system is setup for vehicles with a manual transmission. For vehicles with an automatic transmission the safety wire loop on the main unit must
be cut. Before proceeding to the installation, make sure that the vehicle does not attempt to start when the when the vehicle is in the "drive" or "reverse" position. If an
automatic transmission vehicle starts when the transmission is in gear, ensure that the safety wire loop on the unit is not cut. Once the safety wire loop is cut, the system
is considered an automatic transmission remote-starter indefinitely. Once a loop is cut all warranties, guaranties, and liability is immediately void if the unit is install on
a manual transmission vehicle.Neither the manufacturer or distributor of this module is responsible of damages of any kind indirectly or directly caused by this module,
except for the replacement of this module in case of manufacturing defects. This module must be install by qualified technician. This instruction guide may change
without notice. To download the installation guide, user guide, or the latest quick installation guide, visit: WWW.FORTIN.CA
Technical support: TEL: 514-255-4357 / 1-877-336-7797
Copyright © 2014-2021, FORTIN AUTO RADIO INC ALL RIGHTS RESERVED MADE IN CANADA
STEP 1
OR
3x
Insert the key
and turn it to the
ignition (ON/RUN)
position.
Parking Lights flashes (after Shutdown) :
1x
Normal stop (Brake, Park Brake)
3x
Runtime expired or shut down by transmitter
4x
No tachometer signal
5x
Hood open
6x
Over crank threshold (8 seconds)
STEP 2
Within
10 seconds
press and
3x
release
the Valet
System disarmed
switch or
the antenna
button
3 TIMES
.
System dis-
armed :
LED is OFF
and in valet
mode :
LED is ON.
ALARM DIAGNOSTICS
Parking Lights flashes (after disarm) :
3x
Door open – zone 3
4x
Shock sensor – zone 4
5x
Hood open – zone 5
6x
Trunk open – zone 6
REV.:20210204
PAGE 6
Advertisement
