DSE
Canada Inc
Manual or Automatic transmission
The command module is set by default to operate in
a vehicle equipped with a Manual transmission.
For an Automatic transmission refer to
Note
:
Remember to always
To code the transmitter (Hand brake must be On or White/Blue Grounded)
A -
1-It is mandatory to override the starter kill and to reactivate it before proceeding to the
following steps :
a-Turn the key to Ign On and within 6 sec, press and hold the programming button ,
system will chirp once with 1 parking light flash and LED will stay On for 5 sec then Off
for 5 sec continuously
b-Repeat the same procedure as in above step a , system will chirp twice with 2 parking
light flashes and LED will turn Off . Turn Off Ignition.
2- Immediately after the system chirps twice, turn the key to Ign On, within 6 sec , push
and release Slowly foot brake pedal 3 times = LED will flash rapidly, press LOCK
button of the transmitter immediately (within 5 sec). One long chirp will sound to
confirm with parking lights flashing.
To code a second and third transmitter, press same LOCK button of the respective
transmitter one after the other.
B - O
VERRIDE
To Override the alarm and starter kill
1-Turn the key to Ign On and within 6 sec.
2-Press and hold the programming button .
3-Siren or horn will stop sounding, alarm and
starter kill will be cancelled instanly in
case of lost or malfunction of the
transmitter.
To reactivate the alarm function, repeat step
1 and 2 . System will chirp Twice (2) with 2
parking light flashes to confirm.
TECHNICAL SUPPORT 514-255-0446 & 1-800-667-6820
5540 Boul. Metropolitain Est, St-Leonard, Qc., H1S 1A6 Tel. : 514-255-2720 Fax : 514-255-1367
FAR 040526
CERTIFIED ISO 9001 PRODUCT
INSTALLATION GUIDE
the loop.
reset
the unit ( power off/on) after cutting the loop
(system is NOW in Valet/Override).
11/08/04
FS 105
with ALARM
Turn Off Ignition.
V
ALET
(Sleep Mode)
To put the system in "Sleep Mode" for car
servicing or in "Valet Parking"
1-Turn the key to Ign On and within 6 sec.
2-Press and hold the programming button
3-System will chirp Once (1) with 1 parking
light flash for Valet mode activated (On).
LED will stay ON for 5 sec then Off for
5sec continuously.
4-To turn Off the "SleepMode" or the "Valet
Parking", repeat steps 1 and 2. System will
chirp Twice (2) with 2 flashes to confirm.
and cut
Fig 1
1