Mitsubishi Heavy Industries SRK100VNXPZSX Technical Manual page 160

Item
Power source
Nominal cooling capacity (range)
Nominal heating capacity (range)
Power consumption
Max power consumption
Running current
Inrush current, max current
Operation
data Power factor
EER
COP
Sound power level
Sound pressure level
Silent mode sound pressure level
Exterior dimensions (Height x Width x Depth)
Exterior appearance
( Munsell color )
Net weight
Compressor type & Q'ty
Compressor motor (Starting method)
Refrigerant oil (Amount, type)
Refrigerant (Type, amount, pre-charge length)
Heat exchanger
Refrigerant control
Fan type & Q'ty
Fan motor (Starting method)
Air flow
Available external static pressure
Outside air intake
Air filter, Quality / Quantity
Shock & vibration absorber
Electric heater
Remote control
Operation
Room temperature control
control
Operation display
Safety equipments
Refrigerant piping size ( O.D. )
Connecting method
Installation Attached length of piping
data
Insulation for piping
Refrigerant line (one way) length
Vertical height diff. between O.U. and I.U.
Drain hose
Drain pump, max lift height
Recommended breaker size
L.R.A. (Locked rotor ampere)
Interconnecting wires Size x Core number
IP number
Standard accessories
Option parts
Notes (1) The data are measured at the following conditions.
Item Indoor air temperature
Operation DB
Cooling 27˚C
Heating 20˚C
(2) This air-conditioner is manufactured and tested in conformity with the ISO.
(3) Sound level indicates the value in an anechoic chamber. During operation these values are somewhat higher due to ambient conditions.
(4) Select the breaker size according to the own national standard.
(5) The operation data indicates when the air-conditioner is operated at 400V 50Hz or 380V 60Hz.
(6) Indoor unit specifications for one unit. Capacity and operation data is two indoor units are combined and run together.
(7) Branching pipe set "DIS-WA1"×1(option). ① : Pipe of O/U~Branch. ② : Pipe of Branch~I/U
Model
Indoor unit SRK50ZSX-S (2 units)
kW
kW
Cooling
Heating kW
Cooling
Heating A
Cooling
%
Heating
Cooling
Heating
Cooling
Heating
Cooling dB(A) Hi : 44 Me : 39 Lo : 31 ULo : 22
Heating Hi : 46 Me : 41 Lo : 33 ULo : 23
mm
Munsell : ( 8.0Y 9.3/0.1 ), RAL : 9003
kg
kW
kg R410A 3.8kg (Pre-charged up to the piping length of 30m) Outdoor unit
Louver fins & inner grooved tubing
W 42 x 1 < Direct line start >
Cooling Hi : 14.3 Me : 12.4 Lo : 7.8 ULo : 5.4
3
m /min
Heating Hi : 17.3 Me : 14.3 Lo : 9.8 ULo : 6.2
Pa
Polypropylene net ( washable ) x 2
Rubber sleeve (for fan motor)
W
(option) wired : RC-EX3, RC-E5, RCH-E3
Liquid line: I/Uφ6.35 (1/4") ②φ9.52(3/8")x0.8 ①φ9.52(3/8")x0.8 O/Uφ9.52 (3/8")
mm
Gas line: I/Uφ12.7 (1/2") ②φ12.7(1/2")x0.8 ①φ15.88(5/8")x1.0 O/Uφ15.88 (5/8")
m
m
m Max.30m (Outdoor unit is higher)
Hose connectable with VP16
mm
A
A
φ1.6mm×3 cores (including earth cable) / Termainal block (Screw fixing type)
Mounting kit, Clean filter
Outdoor air temperature
WB DB
19˚C 35˚C
— 7˚C
-
SRK100VSPZSX
3 Phase 380-415V 50Hz / 380V 60Hz
10.0 [ 4.0(Min.)-11.2(Max.)]
11.2 [ 4.0(Min.)-12.5(Max.)]
2.84
2.86
4.00
4.2 / 4.4
4.2 / 4.4
5 , 15
98
98
3.52
3.92
59
62
—
305 × 920 × 220
Fine snow
13
—
—
—
Electronic expansion valve
Tangential fan x 1
0
Not possible
—
Thermostat by electronics
RUN: Green, TIMER: Yellow, ECO: Blue
Internal thermostat for fan motor
Frost protection thermostat
Abnormal discharge temperature protection.
Flare piping
—
Necessary (both Liquid & Gas lines)
Max.50m
—
—
5.0
IPX0
—
The pipe length is 7.5m.
Standards
WB
24˚C
ISO5151-T1
6˚C
159
-
'17 • PAC-T-257
Outdoor unit FDC100VS
70
49
—
845 × 970 × 370
Stucco white
( 4.2Y7.5/1.1 ) near equivalent
83
RMT5126MDE2×1
Direct line start
0.9 (M-MA68)
Straight fin & inner grooved tubing
Propeller fan × 1
86 < Direct line start >
75
73
0
—
—
Rubber sleeve (for compressor )
20 (Crank case heater)
Interface kit : SC-BIKN-E
Flare piping
—
Max.15m (Outdoor unit is lower)
Holes size φ20 x 3pcs
—
IP24
Edging
PCA001Z717
H