Rangemaster 110 Gas User Manual page 31

WARNING - SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.
13. To Change Grill Injector
Remove the hotplate control panel, see 2.
spring clip
grill injector holder
Lift up the spring clip retaining the grill injector holder
and slide the injector holder out of the burner venturi.
Remove grill jet from adaptor and fi t new jet (see table
below for correct jet). Put the injector holder back in
the burner venturi.
14. To Change Grill Burner
Remove grill injector see 13.
A grill electrode plate fi xing screw
B position of grill burner fi xing screws
C front shield fi xing screws
D grill venturi
Remove the 2 screws holding the front shield and
remove the shield. Turn the grill venturi clockwise to
clear the front cross-member, lift up and remove. For
models with ignition disconnect the electrode lead
and remove the screw holding the plate around the
grill electrode. Support the grill burner from below and
remove the two screws (under the foil wrap) securing
grill burner the top of grill chamber. Remove grill
burner.
Reassemble in reverse order taking care not to
damage the grill electrode (where fi tted).
15. To Change Grill Electrode
Remove the grill burner see 14. Withdraw electrode
and pull off electrode lead. Fit lead to new electrode.
Reassemble in reverse order and check ignition is
satisfactory.
16. To Remove an Oven Burner
Open oven door and remove oven furniture. Remove
securing screw at the right hand end. The burner is
held in place by dimples in the mounting bracket. Slide
the burner to the left and lift up taking care not to
disturb the fl ame supervision device probe position .
Reassemble in reverse order. Check the fl ame
supervision device probe has not been disturbed.
17. To Change Oven Burner Assembly
Open oven door. Disconnect the tube nut and tubing.
Remove screw holding the oven burner assembly and
withdraw complete assembly. Remove oven burner
Fit oven burner to new assembly. Replace complete
assembly in the oven. Reconnect tube nut.
Check appliance is gas sound. Check correct fl ame
supervision device operation
18. To Change Oven Burner Injector
The jet is fi xed to the oven burner. Change the oven
burner assembly - see 17.
31