Changing The Prodigy Version - Cisco FLUIDMESH FM4200 Mobi Installation And Configuration Manual

Cisco Ultra-Reliable Wireless Backhaul FM4200 Mobi
Figure 21. Configurator window heading block
If the unit has been set to Bridge Mode, you must set the Bridge ID of the
remote unit to which the local unit must be linked. Set the Bridge ID by
doing the following steps:
1. Click the Remote [Unit model] Bridge ID: drop-down
(page
Figure 22. General Mode window (Remote Bridge Unit
section)
2. Click one of the following options:
• AUTO: The local unit will automatically establish a wireless
• Alternatively, choose the correct unit from the list of
3. Save the operational mode settings by clicking the Save button.
Alternatively, clear the settings by clicking the Reset button.

Changing the Prodigy version

The Prodigy Version box (below) contains the Prodigy version selector.
© 2020 Cisco and/or its affiliates. All rights reserved.
61)).
bridge connection with the closest available Fluidmesh unit
that is set to Bridge Mode.
available units.
IMPORTANT
Prodigy version selection is only available if the Cisco FM4200
Mobi is set to Mesh Point mode or Mesh End mode. If the unit
is set to Bridge mode, the Prodigy Version selector will not be
available.
(Figure 22
Page 61 of 177