Table of Contents
Advertisement
Figure 25. General Mode window (Remote Bridge Unit
section)
2.
Click one of the following options:
• AUTO: The local unit will automatically establish a wireless
• Alternatively, choose the correct unit from the list of
3.
Save the operational mode settings by clicking the Save button.
Alternatively, clear the settings by clicking the Reset button.
Changing the Prodigy version
The Prodigy Version box (below) contains the Prodigy version selector.
Remember that all Fluidmesh devices within a network must use the
same Prodigy version.
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
bridge connection with the closest available Fluidmesh unit
that is set to Bridge Mode.
available units.
IMPORTANT
Prodigy version selection is only available if the Cisco FM3500
Endo is set to Mesh Point mode or Mesh End mode. If the unit
is set to Bridge mode, the Prodigy Version selector will not be
available.
Page 65 of 177
Advertisement
Table of Contents
