Operating The Unit In Mesh Point Mode Or Mesh End Mode - Cisco FLUIDMESH FM4200 Mobi Installation And Configuration Manual

Backhaul FM4200 Mobi Cisco Ultra-Reliable Wireless
5.a.b.c
The triplet a.b.c uniquely identifies the individual physical hardware unit,
and cannot be changed.
The unit ID number is used to identify the physical hardware units within
the configurator interface that is used for configuration of the unit.
A simplified diagram demonstrating the relationship between a wired LAN,
and a linked mesh radio network containing a mesh end unit and mesh
point units, is shown in
Figure 5. Fluidmesh Network Addressing

Operating the unit in Mesh Point mode or Mesh End mode

If the Cisco FM4200 Mobi radio transceiver unit is installed as part of a
mesh network architecture, it can be set to operate in either of two
operating modes:
© 2020 Cisco and/or its affiliates. All rights reserved.
Figure 5 (page 22).
Page 22 of 177