Table of Contents
Advertisement
Backhaul FM4200 Mobi
Cisco Ultra-Reliable Wireless
3. Check the round, knurled nuts of the QMA
connectors for tightness (above). If any round
nuts are loose, tighten them by hand only.
© 2020 Cisco and/or its affiliates. All rights reserved.
4. Slide a section of Nylon heat-shrinkable tubing
over each unconnected antenna cable (above).
5. Push the male QMA plug of the antenna cable
into the female QMA plug of the unit.
6. Screw the threaded sleeve of the male plug
onto the female plug. Tighten the connection by
hand only.
7. Slide the lengths of Nylon heat-shrinkable
tubing over the tightened QMA connectors.
8. Use a heat gun to shrink the tubing onto the
connectors.
Page 42 of 177
Advertisement
Table of Contents
