Backhaul FM4200 Mobi
Cisco Ultra-Reliable Wireless
2.
Connect the unit to a VLAN that is part of the local wireless
network by checking the Enable VLANs check-box.
3.
Check the Enable VLANs check-box.
4.
Enter the management identification number of the VLAN (used
to communicate with the device's operating system) in the
Management VLAN ID: field.
5.
Enter the native identification number (the VLAN ID implicitly
assigned to untagged packets received on trunk ports) in the
Native VLAN ID: field.
6.
Save the VLAN settings by clicking the Save button. Alternatively,
clear the settings by clicking the Reset button.
Rules for packet management
Default VLAN configuration
The factory-set VLAN parameters for the unit are as follows:
Management VLAN ID (MVID)
Native VLAN ID (NVID)
Native VLAN processing
Port mode (all Ethernet ports)
Traffic classes
The system classifies incoming data packets according to the following definitions:
Signaling
© 2020 Cisco and/or its affiliates. All rights reserved.
Figure 46. Configurator GUI (VLAN SETTINGS dialog)
NOTE
The same Management VLAN ID must be used on all
Fluidmesh devices that are part of the same mesh
network.
Parameter
Default value
1
1
Enabled
Smart
Ethernet protocol type $8847 or $09xx
Page 118 of 177