Table of Contents
Advertisement
Backhaul FM4200 Mobi
Cisco Ultra-Reliable Wireless
• principal: The unit will be set as the center unit within a
• SUBORDINATE: The unit will be set as a subordinate unit
• OFF: The FluidMAX engine will be disabled.
3.
If the operating mode is set to principal or SUBORDINATE, enter
a unique cluster ID tag in the FluidMAX Cluster ID field.
4.
If the operating mode is set to SUBORDINATE, check the
FluidMAX Autoscan check-box to allow the principal unit of the
local mesh cluster to dictate the frequency on which the unit will
transmit and receive.
5.
If the FluidMAX Autoscan check-box is checked, the Include
5-10 MHz Channels in Autoscan check-box will become
available. Check this check-box to increase the scan resolution
from the default of 20, 40 or 80 MHz to 5-10 MHz.
6.
Click the Save button to save your settings. Alternatively, clear
the settings by clicking the Cancel button.
Using the Max TX Power setting
The radio automatically computes the maximum transmission power it can
legally use at any moment. It does by subtracting the fixed antenna gain
value from the maximum power level prescribed by the FCC EIRP
regulation governing each U-NII band.
Due to this operating characteristic, you can only adjust the Select TX
Max Power setting to values lower than the maximum available
transmission power value.
Using the Data Packet Encryption setting
This setting controls whether Advanced Encryption Standard (AES)
encryption is applied to outgoing data packets.
© 2020 Cisco and/or its affiliates. All rights reserved.
time-division multiple access (TDMA) protocol or the
carrier-sense multiple access (CSMA) protocol.
mesh cluster featuring a 'star' topology. If the unit is set as
a principal, it will dictate the operating frequency of the
mesh cluster of which it is a principal unit.
within a mesh cluster featuring a 'star' topology. If the unit
is set as a Subordinate, and its Autoscan feature is
enabled, the unit will scan the spectrum of available
frequencies for a principal unit that shares its Cluster ID,
and its frequency selection feature will be disabled.
NOTE
Under normal circumstances, leave the Include 5-10
MHz Channels in Autoscan check-box unchecked.
Page 93 of 177
Advertisement
Table of Contents
