Table of Contents
Advertisement
Cisco Ultra-Reliable Wireless
Backhaul FM4200 Mobi
2.
Enter the IP address of the other unit in the Ping (10 packets
only) field
Figure 28. Advanced Tools window (Ping test tool)
3.
Click the Run button to the right of the IP address field.
• The ping test result will be shown below the test controls.
Using the Bandwidth Test tool
The Bandwidth test can be run with the network under load (to test
operational performance), or with the network unloaded (to test installed
capacity). The test tool generates a stream of packets at a rate of 4
Mbits/sec to test available network path throughput.
To use the Bandwidth test tool, do the following steps:
1.
Determine what wireless link is to be tested between the
Fluidmesh unit and another unit in the wireless network. Get the
IP address of the other unit.
2.
Enter the IP address of the other unit in the Bandwith test
(4Mbit/s UDP): field
© 2020 Cisco and/or its affiliates. All rights reserved.
(Figure 28 (page
IMPORTANT
Bandwidth rate computation is CPU-intensive, and must be
regarded as indicative only. Note that bandwidth testing tends
to underestimate the actual link throughput.
(Figure 29 (page
89)).
90)).
Page 89 of 177
Advertisement
Table of Contents
