12.17
Installing front fender
12.18
Removing the shock absorber
12.19
Installing the shock absorber
Main work
–
Position front fender. Mount and tighten screws
Guideline
Remaining screws,
chassis
V00341-11
–
Mount and tighten screws
Guideline
Remaining screws,
chassis
V00340-11
Finishing work
–
Install the headlight mask with the headlight. (
–
Check the headlight setting. (
Preparatory work
–
Raise the motorcycle with a lift stand. (
Main work
–
Remove screw
as far as possible without blocking the rear wheel. Secure the
rear wheel in this position.
–
Remove screw
remove the shock absorber.
S03479-10
Main work
–
Push splash protector
absorber. Mount and tighten screw
Guideline
Screw, top
shock absorber
–
Mount and tighten screw
S03479-11
SERVICE WORK ON THE CHASSIS 12
M6
10 Nm (7.4 lbf ft)
2
.
M6
10 Nm (7.4 lbf ft)
p. 126)
1
and lower the rear wheel with the link fork
2
3
, push splash protector
1
to the side and position the shock
2
.
M12
80 Nm (59 lbf ft)
3
.
1
.
p. 124)
p. 64)
to the side, and
Loctite
®
2701™
77