CAME LHS A/01 Installation And Configuration Manual page 18

Programming proximity cards or tags*
*LHS V/01 PLUS model only
This function is used to program proximity cards or tags, and assign one or more outputs to each to be controlled.
Do this when there are no internal receivers being associated.
Each new programmed card/tag overwrites the previous one.
①
In [Programming calls], run the proximity card or tag over the RFID reader.
②
Assign a function to the card/tag by pressing and holding the corresponding call button. Continue to press the button until
you hear a tone to confi rm.
Key
P1
P2
P3
P4
Saved cards and tags can be deleted by restoring the device to factory settings. See the paragraph [Restoring
factory settings].
Output/Function
Door release
Auxiliary relay
Relay 1 of actuator (e.g. VSL/2)
Relay 2 of actuator (e.g. VSL/2)