Tm Fast Debug Connector - Siemens SIMATIC S7-1500/ET 200MP Manual

5.2.3

TM FAST Debug Connector

For application development and commissioning, you can load the hardware components
(Page 10) Intel FPGA Download Cable (USB blaster) and TM FAST Debug Connector the
TM FAST application directly in the FPGA of the module and debug them. For this, insert the
TM FAST Debug Connector into the module enclosure from above and activate the FPGA
debug interface with the corresponding command in the commissioning editor (Page 26).
The MAINT LED display lights up yellow until you disable the FPGA debug interface with the
corresponding command in the commissioning editor or by performing a cold restart of the
system.
The TM FAST Debug Connector is inserted into the module enclosure from above here.
NOTICE
Remove TM FAST Debug Connector after commissioning
When commissioning is completed, you must disable the FPGA debug interface and remove
the TM FAST Debug Connector.
Technology module TM FAST (6ES7554-1AA00-0AB0)
Equipment Manual, 04/2023, A5E52301130-AA
5.2 Handling the TM FAST application
Programming
43