Installing The Sma Connector - Siemens LOGO! CIM Operating Manual

4.3.2

Installing the SMA connector

Requirement
• The device is disconnected from the power supply and the DIAG LED goes out.
Procedure
Follow the steps to install the SMA connector.
1. Press the marked recesses on both left and right sides of the module with a flat-blade
screwdriver to loosen and then remove the middle housing.
2. Remove the shelter on the middle housing.
LOGO! CIM
Operating Manual, 10/2021, A5E51250518-AA
Mounting and connecting the device
4.3 Installing expansion modules
33