Siemens SIMATIC S7-1500/ET 200MP Manual page 25

Configuring/address space
4.2 Parameters of the configuration software
Description of parameters
Parameter
Basic parameters: Diagnostics
Enable diagnostic interrupt on wire
break
Error at digital outputs
Missing supply voltage L+
Basic parameters: TM FAST application
Load TM FAST application during
startup
Always activate TM FAST application •
Reaction to CPU STOP
Inputs DI0 - DIQ11
Input delay DIm
24
Description
Activates the diagnostic interrupt if there is a wire break of the
input signals CH0 to CH7.
Activates the diagnostic interrupt "Error at digital outputs".
Activates the diagnostic interrupt "Supply voltage missing".
• Activated: A TM FAST application present in the flash
memory is automatically loaded into the FPGA when the
module starts up.
• Not activated: You must download the TM FAST application
into the FPGA by using the LTMFAST_ControlREC (Page 31)
instruction (data record 100) or by using the Intel FPGA
Download Cable (USB blaster).
Activated: The TM FAST application is activated automatical-
ly after it is loaded into the FPGA.
• Not activated: You have to activate the TM FAST application
by using the LTMFAST_ControlREC (Page 31) instruction (da-
ta record 100).
Selection of reaction to CPU STOP:
• Disable all outputs: The module switches off all outputs up
to the next STOP-RUN transition. After a STOP-RUN transi-
tion, the TM FAST application retakes control over the out-
puts.
• Take over from TM FAST application: The module continues
to operate. The outputs continue to switch according to the
TM FAST application.
Selects the input delay for the signal at the respective digital
input for suppressing interferences. Changes to the signal are
only detected if they remain stable for longer than the config-
ured time.
Technology module TM FAST (6ES7554-1AA00-0AB0)
Equipment Manual, 04/2023, A5E52301130-AA