HP 4262A Operating And Service Manual page 16

Model 4262A Section I
Table 1-1
Table 1-1. Specifications (Sheet 2 of 4).
C-D, C-QMEASUREMENT
120Hz|1000pF |10.00nF|100.0nF|1000nF [10.004F[100.0uF|1000uF [10.00mF
C 1kHz|100.0pF{1000pF |10.00nF|100.0nF 1000nF|10.00xF|100.0uF|1000uF
10kHz| 10.00pF|100.0pFj1000pF {10.00nF|100.0nF|1000nF |10.00uF{100.0uF
Ranges
D .001~19.9 (2 Ranges)
Q™ 0.05~-1000 (4 Ranges)
o 1V or 50mV (LOW LEVEL) ]
Test Signal W [100A 1004A 1mA 10mA 40mA|
Level =2 AUTO [ Sameas i} Mode || Sameas 4rw Mode |
[ 0.2% + 1 counts | (Test signal level; 1V)
{u} [ 2= [ 0.3% + 2 counts | (Test signal level; 50mV)
C Accuracy *3 A (At 120Hz, 1kHz) | 0.83%+2counts || 3% |[ e'
(At 10kHz) | 0.3% +2counts |[1% + 2][5% + 2]
AUTO | | Sameas ¥ Mode || Sameas 4w Mode |
[ 0.2% + (2 + 200/Cx) counts | At 120Hz, 1kHz
| 055% + (2.+ 200/Cx) counts ] L Lest signal level; 1V)
R | 0:3% + (2 + 1000/Cx) counts | At 120Hz, 1kHz
DA [1.0% + (2 1000/Cx) counts |\ 0" 50 evel; 50mV)
v
(At120Hz, 1kHz) [
0.3% + (2 + Cx/500) counts
|f-6-S5)
(At 10kHZ) L 0.5% + (2 + Cx/500) counts I[l%f(fi' Cx 1IE%+(54
o}
500 00!
51
AUTO [ Sameas T+ Mode || Sameas -AM#w Mode |
*1 Calculated from D value as a reciprocal number.
*2 Typical data, varies with value of D and number of counts.
*3 #(% of reading + counts). Cx is capacitance readout in counts. This accuracy only applies for
D values to 1.999. (For higher D values, refer to General Information).
*4 (5% + 2 counts) at 1kHz.
Note: C accuracy for higher D values are unspecified.
1-3