Technical Safety - Miele PWM 511 Operating And Installation Instructions

Warning and Safety instructions
10

Technical safety


Before installing and operating the washing machine, check it for
any visible exterior damage. Do not install or operate a damaged
washing machine.

The electrical safety of this washing machine can only be
guaranteed when continuity is complete between it and an effective
earthing system which complies with current local and national safety
regulations. It is most important that this basic safety requirement is
present and regularly tested and, where there is any doubt, the on-
site wiring system should be inspected by a qualified electrician.
Miele cannot be held liable for the consequences of an inadequate
earthing system (e.g. electric shock).

Unauthorised repairs could result in unforeseen dangers for the
user, for which the manufacturer cannot accept liability. Repairs must
only be carried out by a Miele authorised service technician,
otherwise any subsequent damage will not be covered by the
warranty.

Do not make any alterations to the machine, unless authorised to
do so by Miele.

The washing machine must be disconnected from the mains
electricity supply before any maintenance, cleaning or repair work is
carried out. The washing machine is only isolated from the electricity
supply when
- it is switched off at the wall socket and the plug is withdrawn, or
- the mains fuse is disconnected, or
- it is switched off at the mains circuit breaker.
For more information, see "Installation – Electrical connection".

The washing machine may only be connected to the water supply
using the new hose set supplied with the machine. Old hoses must
not be re-used. Check the hoses regularly for signs of wear. Change
the hoses in good time to avoid the risk of leaks and water damage.
The water flow pressure must be at least 100 kPa and must not
exceed 1000 kPa.

If leakages occur, remedy their cause before operating the washing
machine again. Immediately disconnect the washing machine from
the electricity supply when leaking occurs.

Faulty components must only be replaced by genuine Miele
original spare parts. Miele can only guarantee the safety standards of
the machine when Miele replacement parts are used.

Please observe the instructions in "Installation and connection"
and "Technical data".